From 5ed6b039f589931389bf01bad0f0ca8cea6e9d2e Mon Sep 17 00:00:00 2001 From: Uwe Hermann Date: Thu, 11 Dec 2014 08:51:12 +0100 Subject: swd: Move README into the respective dir(s). --- swd/stlink_openocd/README | 53 +++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 53 insertions(+) create mode 100644 swd/stlink_openocd/README (limited to 'swd/stlink_openocd') diff --git a/swd/stlink_openocd/README b/swd/stlink_openocd/README new file mode 100644 index 0000000..f7540cb --- /dev/null +++ b/swd/stlink_openocd/README @@ -0,0 +1,53 @@ +------------------------------------------------------------------------------- +SWD +------------------------------------------------------------------------------- + +This is a set of example captures of the ARM SWD (version 1) protocol. + +Details: +http://infocenter.arm.com/help/index.jsp?topic=/com.arm.doc.ihi0031c/index.html +(registration required) + + +Logic analyzer setup +-------------------- + + Probe SWD + --------------- + 0 swclk + 1 swdio + + +Data +---- + +Different SWD sessions showing different types of behaviour: + +* stlink_openocd/ + +Using an STLINK-V2 adapter via OpenOCD 0.9.0 development +version. Device under test is a Nordic nRF51822. + +Command line: + + $ openocd -f interface/stlink-v2.cfg -c 'transport select hla_swd' \ + -f target/nrf51.cfg + +** stlink_openocd/init.sr + Intiliasing device, IDCODE read, etc. + OpenOCD args: -c "init; exit" + +** stlink_openocd/init_write_0xabbabeeb.sr + Initialise, write 20 bytes of 0xabbabeeb at start of RAM. + OpenOCD args: -c "init; halt; mww 0x20000000 0xabbabeeb 20; exit" + +** stlink_openocd/wait_retry.sr + Capture showing an SWD WAIT with overrun mode not enabled (in contrast to + ftdi_openocd/wait_retry.sr), adapter immediately retries and gets an OK + response. + + For this capture OpenOCD was patched with this change (known to induce + SWD WAITs): http://openocd.zylin.com/#/c/2204/ + + OpenOCD args: -c "init; reset halt; flash fillw 0 0xabbabeeb 2048; exit" + -- cgit v1.2.3-54-g00ecf