## ## This file is part of the sigrok project. ## ## Copyright (C) 2012 Uwe Hermann ## ## This program is free software; you can redistribute it and/or modify ## it under the terms of the GNU General Public License as published by ## the Free Software Foundation; either version 2 of the License, or ## (at your option) any later version. ## ## This program is distributed in the hope that it will be useful, ## but WITHOUT ANY WARRANTY; without even the implied warranty of ## MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the ## GNU General Public License for more details. ## ## You should have received a copy of the GNU General Public License ## along with this program; if not, write to the Free Software ## Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA ## ''' 1-Wire protocol decoder. The 1-Wire protocol enables bidirectional communication over a single wire (and ground) between a single master and one or multiple slaves. The protocol is layered. - Link layer (reset, presence detection, reading/writing bits) - Network layer (skip/search/match device ROM addresses) - Transport layer (transport data between 1-Wire master and device) Transport layer The transport layer is the largest and most complex part of the protocol, since it is very device specific. The decoder is parsing only a small part of the protocol. Annotations: The next link layer annotations are shown: - RESET/PRESENCE True/False The event is marked from the signal negative edge to the end of the reset high period. It is also reported if there are any devices attached to the bus. The next network layer annotations are shown: - ROM val The 64bit value of the addressed device is displayed: family code (1B) + serial number (6B) + CRC (1B) - FUNCTION COMMAND val name The requested FUNCTION command is displayed as an 8bit HEX value and by name. - DATA val Data intended for the transport layer is displayed as an 8bit HEX value. TODO: - add CRC checks for transport layer ''' from .maxim_ds28ea00 import *