From 6a15597a7b3f901b566b7bfc8c484a14e0fb6a11 Mon Sep 17 00:00:00 2001 From: Uwe Hermann Date: Sun, 13 Apr 2014 19:57:43 +0200 Subject: Rename 'probe' to 'channel' everywhere. Variables of type 'struct srd_channel *' are consistently named 'pdch' to make them easily distinguishable from libsigrok's 'struct sr_channel *' variables that are consistently named 'ch'. --- decoders/parallel/__init__.py | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) (limited to 'decoders/parallel/__init__.py') diff --git a/decoders/parallel/__init__.py b/decoders/parallel/__init__.py index ea55077..cc1f3d1 100644 --- a/decoders/parallel/__init__.py +++ b/decoders/parallel/__init__.py @@ -20,14 +20,14 @@ ''' This protocol decoder can decode synchronous parallel buses with various -number of data bits/probes and one (optional) clock line. +number of data bits/channels and one (optional) clock line. If no clock line is supplied, the decoder works slightly differently in -that it interprets every transition on any of the supplied data probes +that it interprets every transition on any of the supplied data channels like there had been a clock transition. -It is required to use the lowest data probes, and use consecutive ones. -For example, for a 4-bit sync parallel bus, probes D0/D1/D2/D3 (and CLK) +It is required to use the lowest data channels, and use consecutive ones. +For example, for a 4-bit sync parallel bus, channels D0/D1/D2/D3 (and CLK) should be used. Using combinations like D7/D12/D3/D15 is not supported. For an 8-bit bus you should use D0-D7, for a 16-bit bus use D0-D15 and so on. ''' -- cgit v1.2.3-70-g09d2